国内精品视频一区二区三区_国产白袜脚足j棉袜在线观看_久久九九精品99国产精品_亚洲高清毛片一区二区_久久精品中文无码资源站

Welcome toZhejiang Yuman Electric Technology Co., Ltd.Official website, we focus on the production and sales of high-quality fans!

Tel:86-15068298836 / 13868374889

Home / News / Commonly problematic parts of stainless steel fans

Commonly problematic parts of stainless steel fans

date:[2021-02-24]     pk_hits:

The stainless steel fan is simply a kind of equipment for conveying gas, and its composition is not complicated. Stainless steel fan installation preparation


The main parts of a stainless steel fan are: impeller, volute, air inlet, bracket, motor, pulley, coupling, muffler, transmission (bearing), etc.


After the stainless steel fan is used for a long time, some parts will have problems under the influence of external factors or its own material factors.


Today, I will introduce to you which parts often have problems.


1. Gear


When designing the gear of the stainless steel fan, a certain amount of tooth wear is calculated. During normal use, its wear is negligible.


If the oil level in the gear box is high, it will cause too much oil to heat up during agitation, and the temperature at the bottom of the oil tank will be too high.


If you continue to operate in this situation, the gear will heat up and the gear may be affected by rapid wear, which will cause the impeller blades to contact or the unit to jam.


2. Bearing


The service life of the booster is closely related to the bearing.


Gradual wear may change the position of the shaft until friction occurs between the impeller and the cylinder block or top plate, and sudden bearing failure usually has serious consequences.


Because the impeller shaft assembly is no longer supported and correctly positioned, extensive damage to the casing and gear may occur immediately after the bearing fails.


3. Transmission shaft sealing components


The assembly is composed of two independent lip seals immersed in oil and located in the drive end cover.


If the oil level of the oil gauge rises, it means that the oil leakage through the inner member is excessive, and it should be replaced as an assembly.


Unless the seal or its bearing surface is damaged, the possibility of leakage through the outer member is unlikely.


In addition, the smoothness of the shaft also has a considerable influence on the performance of this type of seal. The operation problem may be caused by reasons other than component damage.


Since the gap is only a few thousandths of an inch, installation changes or pipe support changes may cause interference and friction.


Four, casing


Foreign matter entering the stainless steel fan casing can also cause some trouble.


If you encounter this type of problem, but you find that the inside of the casing is clean, please disconnect the pipe and loosen the mounting bolts, and re-level and align the driver.


After tightening the installation, make sure that all pipes are properly connected to the unit before reconnecting.


The above is the introduction about the problems with stainless steel fan parts. You must check and maintain it regularly during actual use.


Focus on the production of electrical equipment series products

Contact Us

If you have any questions, suggestions and products you want to know, you can contact us at any time. Looking forward to your consultation?

message

主站蜘蛛池模板: 欧美日本免费一区二区三区| 欧美激情一区二区久久久| 人人妻人人澡人人爽欧美精品 | 成人免费视频一区二区| 色欲精品国产一区二区三区av| 免费三级现频在线观看播放| 欧美最猛性xxxxx大叫| 亚洲av无码专区国产乱码不卡| 国产性猛交╳xxx乱大交| 久久精品动漫一区二区三区| 波多野结av衣东京热无码专区| 国产成人无码精品一区在线观看| 国产亚洲精品拍拍拍拍拍| 国产xxxx做受视频| 人禽杂交18禁网站免费| 日本爽快片100色毛片| 麻豆天美国产一区在线播放| 久久人妻公开中文字幕| 国产情侣久久久久aⅴ免费| 国产午夜福利片| 中国熟妇内谢69xxxxx| 最新中文字幕av无码不卡| 精品久久久久久久中文字幕| 国产精品永久在线观看| 天天鲁一鲁摸一摸爽一爽| 国产精品久久久久久av福利| 777米奇色狠狠888俺也去乱| 国产福利一区二区三区在线视频| 东北妇女xx做爰视频| 精品人妻无码视频中文字幕一区二区三区 | 国产熟妇久久777777| 丰满人妻熟妇乱又伦精品软件| 女人和拘做爰正片视频| 亚洲av成人无码久久精品| 97久久久久人妻精品区一| 欧美黑人又粗又大久久久| 亚洲熟妇无码一区二区三区| 欧洲精品码一区二区三区免费看| 欧洲成人一区二区三区| 小蜜被两老头吸奶头在线观看| 少妇又紧又色又爽又刺激视频|